Jan 122011

If you found your Maytag not starting after the last cycle you may have a faulty thermal fuse. This fuse will fail if the dryer overheats for any reason. Here are several possibilities that the fuse could have failed.

-Grounded heater element
-Clogged dryer vent
-Vent hose kinked
-Lint filter clogged

After narrowing down which issue caused the fuse to trip you will need to fix the issue before the fuse is replaced, the fuse will trip again if original condition is still present. On Maytag units the lower half of the front panel will come off and slide down and out of the way. There are screws that line the bottom section of the panel, once off remove the lint filter and lint filter housing, the screws around the blower wheel hold the housing together.  Once removed the lint filter housing will move out of the way to access the fuse.

The one screw will need to be removed to access the thermal fuse. With your volt meter you can confirm that the fuse is bad by testing the resistance or continuity. The fuse should read resistance or continuity.

Once you have fixed the issue that caused this thermal fuse to trip replace and reassembly the dryer for test cycle.  Taking extra precaution with the dryer vent hose when pushing the unit back slide back into position and remove your floor protection.

After diagnosing and saving yourself a few bucks it must feel good! Search the site for any other appliance repair troubles you have and you could find another answer. Thanks for reading our articles your feedback is greatly appreciated!

 Leave a Reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>