Aug 292015
 

The tS error code will flash on a samsung dryer when the thermistor is defective or shorted. A thermistor can fail several different ways. In most cases when these dryer thermistors fail it’s under normal use or “Wear & Tear” per say..

Unplug your appliance before you attempt any repair. 

If you’re extremely handy and know how to use a volt/ohm meter, you will most likely be able to fix the tS error code yourself. Unfortunately the manufacture did not make the thermistor easy to test. The machine will need to be taken apart to test the thermistor.

Once inside you will see the dryer has a thermistor and it has two wires on it. Set the meter to read resistance and check the thermistor with one wire off or both to be safe. If the thermistor reads over 40,000 ohms, replace it because it’s faulty. Samsung dryer thermistors should read roughly 10,000 ohms at room temp. If yours tests good, that would indicate a wiring issue or a faulty control.

Most commonly on these dryers you will find a loose or corroded connection. Usually in the end of a female plug. Clean the contacts really good. Make sure the wires counting the two components are not broken or kinked in any way.

Most of these dryers have two screws holding the top down. Once those screws are removed, the top will slide back and off. Now the front control board can be removed by lifting up on the plastic clips. Once the control panel along the front is off you will see the hidden screws that hold the front panel in place. The two screws inside the front by the lint filter will need to be removed before the front will fall forward enough to unplug the light switch. Once you have made it this far the bulkhead will be removable and then the drum. Working on these samsung appliances really is not very difficult. Especially if you have a little bit of help from someone who knows them inside and out.

Still have questions about your Samsung dryer? You can now Ask Matt on the phone. Samsung Dryer Phone Help You can also use the comment form below.

We know Samsung appliances well. Have a Samsung appliance that’s not quite acting right? Washer not draining fast enough or spinning quite right? Refrigerator making a strange noise or a dryer with an error code.. We can help.

Thanks for taking the time to stop by our site. If you have a moment, drop us a line in the comment form.

May 122011
 

Hi,

Thanks for taking the time to stop by our blog.  If you find one of our reviews or how to articles helpful drop us a line and let us know.  Fisher Paykel dryers have several common issues.  When the dryer stops heating it is more than likely due to a clogged dryer vent.  There is a safety fuse inside fisher paykel dryers that will trip.  When this safety fuse trips the dryer will start run but not heat.  If you and your fisher paykel dryer are in this situation the fuse is resettable.

To gain access to this fuse the top and front of the dryer need to be lifted and removed.  The process is simple and I have provided a link below that is a video that we have made that explains how to open and where the fuse is.

Fisher Paykel Dryer Repair Video Link

The fuse has a small button on the front that needs to be pushed into to reset.  If you have a volt meter check the heating element and make sure it is not grounded.  On some of these dryers the element will sag and touch.  When this happens the element can stay on and cause a over heat condition.  Check the dryers venting if the element is not grounded out.  We know these dryer very well and can assist you with any fisher paykel dryer repair question you may have.  Post your question in our fisher paykel repair forums using the link below.

Fisher Paykel Dryer Repair Forum