Disclosure: Bear in mind that some of the links in this post are affiliate links and if you go through them to make a purchase I will earn a commission. Keep in mind that I link these companies and their products because of their quality and not because of the commission I receive from your purchases.

Washer Tutorials


  12 Responses to “Washer Tutorials”

  1. washer giving f1 error code

  2. I have Samsung WF209ANW washer that will not spin/drain of the final spin cycle – the error code looks like picture of a “lock” not the ND code – that code is not shown in the manual



    • Hi, thanks for taking the time to comment.

      If you could upload of picture of the error code in our forum I would be able to tell you for sure.

      These washing machines have a child lock feature. If that was enabled you wouldn’t be able to start a cycle though.

      “Spin” and “Soil Level” are they buttons you press in at the same time and hold in for 5 seconds to clear the lock message.

      If you are able to upload a photo to the forum, I would be able to better assist you.


  3. I have an LG fuzzy Logic that does everything right except drain and spin out…any advice would be helpful

    • Hi, thanks for taking the time to comment.

      If the washer doesn’t drain, it will not spin out. The first thing to check would be the drain pump for an obstruction. If something is stuck inside, the impeller won’t turn and it won’t drain/spin.


  4. My Maytag washer model # MAH4000AWW will not start. I checked the white button on the inside of the door. It depresses and pops out again fine. I’m not sure what to check beyond that! Any help would be fabulous.

  5. I have a Samsung VRT Washer mdl WF210A, it will not drain nor spin, it’s displaying the nd error code. My question is concerning the location of the pump of this particular unit, I have the filter access point on the lower front . zif you could help me with the location of the pump, so I can check this problem out.


    • Hi, sorry I didn’t see this sooner. The drain pump is located directly behind the filter point your referring to.

  6. I have a wf206law/xaa washer that is flashing the tE (temperature sensor) error. I’ve seen a number of folks suggest that the most common problem is that the wires to it get severed. I’ve begun taking the panels apart to access the bottom of the drum, but I am nervous about the rubber seal. How do I take that off and put it back on?

  7. Have a Samsung WA5471 top loader not draining code (nd). Pulled information on the site to drop the back panel and pump then clean pump then reinstall is that all there is to it?

  8. Hi!

    I have a Fisher & Paykel washing machine, WH70F60W1, which has stopped oscilating the machine. I have tried to run it in Diagnostic mode, which I am guessing is from holding down the Start button when turning on the machine. When I do this I get three dashes on the LCD, but nothing else happens.

    Currently my thoughts are that the motor is kaput, but I am unsure on how to determine this. At first I thought it may have been one of the relays, but they seem to be in tact and working correctly.

    Thanks for your help.

 Leave a Reply

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>