Mar 192011
 

Ge front load washers have a drain pump filter.  This filter is located behind the washers lower access panel.  Three small screws hold the panel in place.  With the screws removed, the washers access panel will slide down and off.  The drain pump filter is inside the drain pump housing. To remove the washer drain pump filter twist the handle counter-clockwise on the front of the pump.  Pull the filter out and clean.

If the washer is full of water, either use hose clamp pliers or the bail the water out of the tub before the filter is removed. Ge and other similar manufactures use drain pump filters on their front load washers.  This prevents stuff from getting past the drain line and into the drain pump impeller to damage the washer.  Having an appliance repair technician out to make this repair would cost around $150 dollars.  If you have found this information helpful, leave a comment below.

 

Jan 132011
 

On most GE front load washers, the drain pump is accessible from the front of the washer. This pump has a filter inside and can catch some pretty amazing stuff.

Here is “How To” on cleaning your GE washers drain pump filter.

-Screwdriver

-Towels

-Hose clamp pliers (if water is in tub)

Start by removing the screws along the bottoms front edge doing so will let the access panel come down and out of the way.

Inside the washer in the middle you will see a white plastic housing with a twist handle on the front this is the filter head.
With the hose clamp pliers clamp the main washer hose that connects to the rear of the pump,this will stop the water in the washer from coming out when the filter head is twisted and removed.

With the clamp in place twist the filter head and slide the filter out,the filter is connected to the handle clean the filter and reinstall back into the drain pump. With the front access panel reconnected set the unit to a normal cycle and let fill to the top. Once the washer starts to go back and forth cleaning the clothes press stop and power the unit off. On Whirlpool and Maytag unit’s they will go into an automatic two minute drain cycle.

Once the machine has powered off turn the dial to drain/spin and press start. This will force the drain pump to come on. If the unit drains you can mark that off the honey-do.