Jan 152011
 

Replacing the door interlock switches on a dishwasher involves removing the screws around the door liner and accessing the door switches.

Dishwasher door switches will often break or in some cases burn up. When this happen the dishwashers lights may be on but the unit may not start.

-Disconnect power
-Remove the screws around the door.
-Set door panel aside
-Remove control housing if necessary
-Carefully remove screw or clip holding switch down
-Pry off wires

Once the wires are disconnected you can test for continuity, the dishwashers door switch should read resistance when in the closed position.

The marking on the switch will verify what position the switch is in when activated and in home position. The NC normally closed contact NO normally open contact and COM common. Depressing the switches actuator on top should result in a resistance reading on the volt meter.

Jan 152011
 

Bosch dishwashers are built with flood switches located in the bottom base pan of the dishwasher. The flood switch is connected to a rod that activates a small interlock switch, when water enters the base pan on a Bosch dishwasher a Styrofoam puck lifts the rod activating the flood switch.

When the flood switch is activated the dishwasher will go into a no fill,  only drain mode, the drain motor may also run with the door open to the unit, this is a sign there is water in the base pan.

Determining where the water entered the base pan can often times be time consuming. Bosch dishwashers have a more complex wash and dry system, more parts this mean smaller work areas, some parts are in sealed compartments, these require lots of time and effort to access.

You may have to watch the unit through a complete cycle before you can diagnose the error. Some of the more common possibilities include

-Sump fill hose (Cracked/brittle)
-Drain hose(Also check drain hose connection)
-Faulty drain pump seal
-Circ pump housing’
-Main sump seal

Any one of these are a possibility and there are many more, spending an hour watching the unit cycle may be the only way to figure out where the water is coming from.

Note also over sud-sing will also cause the unit to leak water into the drain pan. If you recently filled the dishwashers jet dry dispenser, excess jet dry on the door and surrounding areas could create the dishwasher to flood into the pan.